Commode assembly, Adjusting leg height, Additional precautions – Activeforever Drive Wheeled Drop Arm Commode User Manual

Page 2

Advertising
background image

commode assembly

1. Remove contents from box. Depress brass push

pins and insert bucket frame section into first arm.

The push pins will snap into place when frame in

securely in place.
Note: Make sure the back of the bucket frame (the side

with the back rest receptacles) corresponds to the back

of the armrest section.

2. Repeat for second arm section.

3. Insert backrest into backrest receptacles in

commode bucket frame. The brass push pins will

snap into place when secure.

4. Align the padded toilet seat clamps onto the back

frame rail. (Both clamps should sit outside the pail

brackets). Push down on seat until clamps snap

firmly into place. To remove, grasp the back of the

seat and lift.

5. Install commode bucket by dropping into bucket

frame. Reverse to remove.

adjusting leg height

1. Before use, adjust height of each leg to your specific

needs, making sure all legs are at the same height.

When desired height is reached, lock legs into place

by aligning buttons into proper holes, per illustration

above.

2. To be sure legs are locked into place by pushing

down on or by pulling legs.

additional precautions

1. Toilet seat must be in down position before use.

Failure to do so may result in breakage of commode

and possible injury.

2. Do NOT install commode without first reading and

understanding this assembly and instruction sheet.

If you can not understand these instructions, contact

a healthcare, dealer or technical professional before

attempting to install. Otherwise, injury or damage

may occur.

3. Inspect all parts for shipping damage before

assembly. If there is shipping damage -

DO NOT USE. Contact dealer/carrier for further

instructions.

4. Make certain that the height adjusting snap buttons

fully protrude through the same respective hole of

each leg extension. This will ensure that the leg

extensions are securely locked in position and an

even height is achieved (see Figure 1).

5. Ensure ALL screws, nuts and/or bolts are tightened.

6. Check the rubber tips on the leg extensions for rips,

wear or if they are are missing. Immediately replace

any or all if any of these imperfections exist.

7. All four leg extensions with rubber tips MUST touch

the floor simultaneously at all times.

8. Users with limited physical strength should be

supervised or assisted while using commode.

Advertising