AcuRite 50314 Clock User Manual

Page 3

Advertising
background image

3

4

• Replace battery annually or when the clock cannot receive the

atomic signal.

• Keep clock clean, dry and dust-free by cleaning it regularly with

a soft cloth.

• Do not use corrosive cleaners or chemicals on the clock.

• Always store the clock without a battery when not in use.

Mount the Clock

• Utilize the hanger molded into the backside of the clock for wall

mounting.

• Use a securely anchored screw, nail or hook to support the

weight of the clock.

• Ensure the mounting screw/nail head is large enough to secure

the clock and it from slipping off in the event that it is bumped.

Outdoor Use

This only applies to clocks that are labeled for outdoor use.

• Extended periods of cold temperatures (below -4ºF / -20ºC) can

cause alkaline batteries to function improperly. Use lithium

batteries in low temperatures to ensure continuous operation of

the clock.

• To extend the life of the clock, place in an area protected from

direct weather elements.

TROUBLESHOOTING

Problem

Possible Solution(s)

Poor Signal

• Place clock near a window with the

curtains or blinds open to improve signal

reception.
• Place clock more than 3 ft away from

electronics or wiring to minimize

interference. Electronics (computers,

TVʼs, fluorescent lights, microwaves, etc.)

can interfere with signal reception.
• If you do not find good reception on

your first attempt, try again later.

Reception may be impacted by the

weather, season, time of day and solar

activity. The best reception is typically at

night just before/after sunrise and sunset.

In areas and times of very poor

reception, it may take a few days before

the signal can be received.
• On rare occasions the atomic signal

WWVB transmitter is turned off for repair

or maintenance.

Clock will

not synchronize

• Insert a new 1.5 volt “AA” battery
• Take the clock outside on a clear night

and remove the battery. Power it up by

reinserting the battery, which will force it

to search for the atomic signal again. If

the clock works outside but not inside,

you may have an indoor interference

problem.

CARE

Advertising