AcuRite 02020 Lightning Detector - Manual (Page 4)

4
SETUP
Install or Replace Batteries
AcuRite recommends high quality alkaline batteries for the best product
performance. Heavy duty or rechargeable batteries are not recommended.
1. Remove the belt clip.
2. Remove the battery cover.
3. Insert 2 x AAA batteries into
the battery compartment, as
shown. Follow the polarity
(+/-) diagram in the battery
compartment.
4. Replace the battery cover.
5. Replace the belt clip.
PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE
WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.
BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be
used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used
batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire,
as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply terminals.
3 Install Batteries
2 AAA alkaline
batteries Remove
Battery Cover
2
Remove Belt Clip
1
c
c
Pull tab UP to
unlock belt clip
A
Slide belt clip
OFF
B