AcuRite 00534 Timer - Manual (Page 2)

2 • INSTRUCTIONS FOR USE
- 3 - - 2 -
Product Registration
To receive product information, register
your product online. It’s quick and easy!
Log on to http://www.chaneyinstrument.com/product_reg.htm
1. The timer is “always on”.
2. In sleep mode LCD will display 00:00:00. This will not drain battery.
3. MINUTES: Press the “SET MINUTES” button until desired number reached.
Hold the “MINUTES” button down to activate “rapid advance”.
4. SECONDS: Press the “SET SECONDS” button until desired number reached.
Hold the “SECONDS” button down to activate “rapid advance:.
5. START/STOP: Pressing the “START/STOP” button without entering a time
causes the timer to start counting up. Pressing the “START/STOP” button
after entering a time will cause the timer to start counting down from
the time entered.
6. CLEAR: Press the “CLEAR” button to clear the time displayed.
When timer is set but NOT running:
Press the “START/STOP” button to begin counting down from the time entered.
When the timer is running:
Press the “START/STOP” button to stop the countdown.
General Timer Description: This is a countdown timer (this means that when
the timer reaches 00:00 it will sound an alarm). The alarm will sound for
1 minute at 75 db.
3 • WARNING
WARNING: Do not place on or near hot surfaces. Do not immerse unit in water.
General Timer Description:
This is a countdown timer (this means that when the timer reaches 00:00 it will
sound an alarm). The alarm will sound for 1 minute at 75 db.