Acura 2011 TSX Sport Wagon - Manual (Page 249)

247
Replacing Light Bulbs
Continued
M
ain
te
n
an
ce
When replacing, use the following bulbs.
High beam headlight: 60W (HB3)
Low beam headlight: 35W (D2S for high voltage discharge type)
High Beam Headlight
Passenger side
1. Remove the engine coolant reservoir.
Headlight Bulbs
NOTICE
Halogen bulbs get very hot when lit.
Oil, perspiration, or a scratch on the glass can cause
the bulb to overheat and shatter.
The headlight aim is set by the factory, and typically
does not need to be adjusted. However, if you
regularly carry heavy items in the cargo area or tow
a trailer, have the aiming readjusted at a dealer or
by a qualified technician.
The HB3 type is halogen bulb.
When replacing a bulb, handle it by its base, and
protect the glass from contact with your skin or
hard objects. If you touch the glass, clean it with
denatured alcohol and a clean cloth.
The exterior lights’ inside lenses (headlights, brake
lamps, etc.) may fog temporarily after a vehicle
wash or while driving in the rain. This does not
impact the exterior light function.
However, if you see a large amount of water or ice
accumulated inside the lenses, have your vehicle
inspected by a dealer.
Headlight Bulbs
Driver side
2. Remove the fasteners, using a flat-tip
screwdriver. Remove the cover of the air
intake duct and its upper part.
Fastener
Air Intake
Duct
Cover
Engine Coolant Reservoir
31TL7600.indb 247 2010/09/10 15:19:46