Acura 2011 RDX Navigation - Manual (Page 92)

Navigation System 91
System Setup
SETUP Mode
The SETUP function consists of two
main screens that allow you to change
and update information in the system.
To display the
SETUP screen ( Main
Setup ), use the voice control system
and say “Setup” or press the SETUP
button. To change it to the SETUP
screen ( Other ), select the “Other” tab.
You can switch screens by selecting the
tab.
You can use the voice control system to
select any item on the
SETUP screen.
NOTE:
• If some items appear to be grayed out
and cannot be selected, it is because
you did not select
OK on the initial
Disclaimer screen. See System Start-
up on page 17.
• For information on the available
voice commands, see Voice
Command Index on page 165.
SETUP Screen (Main Setup)
From any screen, say “Setup screen” or
press the
SETUP button, and the
following screen appears:
Brightness
The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say “Brightness up”
or “Brightness down.” You can also
select
Brightness and change the
setting by rotating the Interface Dial
knob .
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.
Contrast
The screen contrast has 11 settings. To
adjust the contrast, use the voice control
system and say “Contrast up” or
“Contrast down.” You can also select
Contrast and change the setting by
rotating the Interface Dial knob .
Black Level
The screen black level has 11 settings.
To change the black level, use the voice
control system and say “Black level up”
or “Black level down.” You can also
select
Black Level and change the
setting by rotating the Interface Dial
knob .
NOTE:
You can have separate daytime and
nighttime settings for Brightness,
Contrast, and Black Level. Adjust each
setting when the display is in either
daytime or nighttime mode. Use the
Display Mode button (page 11
and 113) to select Daytime or Nighttime
mode.