AIPTEK PocketCinema V100 - Manual (Page 7)

User’s Manual
Page 7
EN
YPbPr (Optional)
1. Use the YPbPr (Component) cable (not supplied) to connect the YPbPr input
jack on the rear panel of the projector to the external AV signal source. Ensure
that the relevant input (e.g.: Component 1 or Component 2) is enabled in the
“Input Soure” menu.
2. Highlight “Source” and switch to YPbPr mode.
Note:
1. The YPbPr jacks are sometimes labeled Y/CB/Ce. If so, connect the cables to
same colors.
2. If the Input soure menu disappears, press OK button to popup the menu.
External SD/SDHC card slot
A single built-in memory card reader is available for
reading the following flash memory cards: SD and SDHC
card up to 32GB. Gentally insert the card by following the
direction shown below until it reached the bottom of the
slot. To remove the memory card, gently push the top
edge of the card and pull it out.
USB Device
The projector can project the content
from USB device such as USB dongle.
Connect one end of the mini-USB
transfer cable to the mini-USB port of
the unit and the other end to USB
device as shown.
Using Headphones
The projector equips stereo speakers for
providing the best audio performance.
Addionally, you can connect the headphones
to the headphone jack of the unit. When
headphone is connected, the speakers will
automatically turn off.
Warning: Avoid Hearing Damage
Listening at high volume for a long period of time
could cause damage to your ears.