ASRock Fatal1ty Z77 Performance - Manual (Page 30)

30
Fatal1ty Z77 Performance Series Motherboard
English
2.10 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors These four Serial ATA2 (SATA2)
(SATA2_0: see p.4, No. 19) connectors support SATA data
(SATA2_1: see p.4, No. 22) cables for internal storage
(SATA2_2: see p.4, No. 20) devices. The current SATA2
(SATA2_3: see p.4, No. 21) interface allows up to 3.0 Gb/s
data transfer rate. If the eSATA2
port on the rear I/O has been
connected, the internal
SATA2_3 will not function.
Serial ATA3 Connectors These two Serial ATA3 (SATA3)
(SATA3_0: see p.4, No. 18)
connectors support SATA data
(SATA3_1: see p.4, No. 24) cables for internal storage
devices. The current SATA3
interface allows up to 6.0 Gb/s
data transfer rate.
Serial ATA (SATA) Either end of the SATA data
Data Cable cable can be connected to the
(Optional) SATA / SATA2 / SATA3 hard
disk or the SATA2 / SATA3
connector on this motherboard.
SATA2_3 SATA2_2
SATA2_1 SATA2_0
SATA3_1 SATA3_0
USB 2.0 Headers Besides four default USB 2.0
(9-pin USB_4_5) ports on the I/O panel, there are
(see p.4, No. 25) three USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB 2.0
(9-pin USB_6_7) ports.
(see p.4, No. 26)