ASRock 960GC-GS FX - Manual (Page 14)

14
ASRock 960GC-GS FX Motherboard
English
1.6 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA2 Connectors These six Serial ATA2 (SATA2)
(SATAII_1 (PORT 0): connectors support SATA data
see p.2, No. 14) cables for internal storage
(SATAII_2 (PORT 1): devices. The current SATA2
see p.2, No. 15)
interface allows up to 3.0 Gb/s
(SATAII_3 (PORT 2): data transfer rate.
see p.2, No. 12)
(SATAII_4 (PORT 3):
see p.2, No. 11)
(SATAII_5 (PORT 4):
see p.2, No. 10)
(SATAII_6 (PORT 5):
see p.2, No. 9)
Floppy Connector
(33-pin FLOPPY1)
(see p.2 No. 20)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
the red-striped side to Pin1
connect the black end
to the IDE devices connect the blue end
to the motherboard
80-conductor ATA 66/100/133 cable
Primary IDE connector
(39-pin IDE1, see p.2 No. 6)
Note: Please refer to the instruction of your IDE device vendor for the details.
SATAII_1 (PORT 0)
SATAII_2 (PORT 1)
SATAII_3 (PORT 2)
SATAII_4 (PORT 3)
SATAII_5 (PORT 4)
SATAII_6 (PORT 5)