Binatone HB-733 - Manual (Page 5)

5
ENGLISH
SPECIAL SAFETY
PRECAUTIONS
X Before turning the appliance on for the first
time, make sure that all components of the blender
have been properly installed.
X Do not apply too much force when installing the
blender attachment, as it may result in the break-
age of the appliance and in the termination of the
warranty.
X If a smell of burning, foreign sounds or power reduction occur
during the blending process, immediately unplug the appli-
ance from the outlet and clean the blender. If the blender still
malfunctions after cleaning, contact an authorized service cen-
ter.
X It is recommended that original factory packaging should be
used for the transportation of the blender in order to prevent
its parts from breaking.
X If the ingredients are hot, allow them to cool before blending
(maximum temperature: 80 0 C). Never blend hot fat or oil with
the blender.
X Never use the blender to blend paints or solvents.
X Do not attempt to remove any ingredients when the blender is
in operation.
X Always turn the appliance off before removing the attach-
ment.
X Maximum allowed time of blender continuous operation – 1
minute with compulsory pause of not less 1 minute. Operating
time for solid products processing should not exceed 15 sec-
onds.
X The blades of the blender are very sharp. Never touch the
blades of the blender.
X Turn the blender on only after it has been fully assembled.
Always check whether the appliance has been properly as-
sembled before each use.
DESCRIPTION OF THE
APPLIANCE PARTS
Figure A:
1. Body
2. Speed selector
3. Button to set normal speed mode
4. Button to set turbo speed mode
5. Buttons to release blender or whisks
6. Blender
7. Whisk
8. Mincer gear
9. Non-slippery bases / covers
10 a. Mincer blade for bowl A
10 b. Mincer blade for bowl B
11 A. Mincer bowl A - capacity 1250 ml