Binatone CEJ-3300T - Manual (Page 7)

7
ENGLISH
9. While pouring water from the kettle tilt it slightly and gradually. Do
not forget it holds hot water inside.
10.If the water-cools down and you wish to boil it or heat it again, just
switch the kettle on again.
CLEANING AND CARE
1. Before cleaning or storing the kettle, unplug it
from the mains and allow it to fully cool down.
2. In order to avoid an electric shock, do not im-
merse the kettle body (5), its base (12) and
the power cord into water. These components
of the appliance may be cleaned with a damp
soft lint-free cloth without any detergent.
3. In order to clean the filter (4) remove it and wash its exterior with
running water. The filter needs to be washed irrespective of scale
formation on it.
USEFUL ADVICE
In hard water areas it is important to do the de-
scaling regularly to keep the kettle in good working
condition, because too much scale inside may cause
the kettle not to work. For the best performance of
your kettle, decalcify the unit from time to time. The
frequency depends on the hardness of your tap water
and how many times you have used the kettle (e.g.
once for 200 uses). If the water in your house is hard we advise you to
use filtered water as it will slightly decrease scale formation.
2 methods of decalcification:
1. Using 9% white vinegar:
- Fill the kettle with 0.5 liter of hot water and add two tablespoonful
of 9% white vinegar.
- Let the kettle soak for 1 hour without boiling.
- Stir the liquid in the kettle from time to time.
2. Citric acid:
- Mix 25g of citric acid with 0.5 liter of boiling water.
- Pour the mixture in the kettle.
- Leave to soak for 15 minutes.
- Empty your kettle and rinse it two or three times with tap cold
water.
- Repeat the process if needed.
Any other servicing should be performed only by an authorized
service center.
The appliance should not be stored while hot or plugged in. When
not in use, allow the kettle to cool, then put it back into the box and store
out of reach of children in a safe, dry place.