Binatone CI-580 - Manual (Page 6)

6
BEFORE USING
THE APPLIANCE
X Remove all labels from the appliance, wipe it
with soft fabric and put it on a dry plain surface.
X Before using the appliance make sure that
your hair is completely dry
OPERATING INSTRUCTIONS
1. Place the appliance on its base (8) upon a
dry smooth horizontal surface.
2. Connect the power cord plug to the electric
mains and set the switch (6) into the appropriate
position. The Indicator light (7) will light up, show-
ing that the appliance is heating.
3. Wait for the appliance to heat up to the re-
quired temperature (approximately 10 minutes).
4. Select a small lock of hair (approximately 15 mm wide) and
comb it from roots to tips.
5. Press the lever (5) to open the hair clip (3).
6. Place the ends of the hair between work surface (2) and hair
clip (3).
7. Rotate the appliance by the handle (11) to wind the hair onto
the work surface. For your convenience you may rotate the
handle (11) with one hand and support the appliance by the
non-heating tip (1) with the other.
8. Treat each lock for around 10- 20 seconds.
9. Carefully release the hair by lifting the lever (5). Let the hair
cool down.
10. Continue operation as described above to treat all of your
hair.
11. Always unplug the appliance immediately after use.
Brush sleeve (12)
This attachment adds volume to your hair style.
Put fixing loops of the sleeve (12) on the base screws (8) as
shown on Pic B.
Spiral sleeve (13)
This attachment makes spiral curls.
Press the lever (5), put on the sleeve under the short clip (4)
and fix it with the lever (5) and the clip (4). Make sure the sleeve
(13) is put on correctly (see pic. C).