Binatone RL-595 - Manual (Page 7)

7
ENGLISH
Using the appliance as the lantern with
automatic switch-on
X Connect the lantern to the electric network by inserting the
plug into a power socket.
X Set the operation mode switch (5) to «ON».
X After electric power supply is cut off, the appliance will start
operating in the autonomous emergency mode. If light does
not go on, please pull the rope switch.
Warning: when you stop using the lantern, set the
operation mode switch to «OFF» in order to save
battery charge.
The emulation mode of emergency mode
(only for RL-595)
You can check the functioning of emergency lighting network
by pressing the «Test» button (14), emulating power supply cut-
off.
Replacing the external safety fuse (only for
RL-595)
X The emergency lantern RL-595 features the built-in external
safety fuse (17), installed on the body of the appliance (6).
This safety fuse protects power circuit of the rechargeable
battery.
X To replace the safety fuse, unscrew the protection cover with
a cross screwdriver, take the fuse out of the receptacle and
replace it with a new one.
Warning: use only the safety fuses with the rating value of
3A 250 V to replace the burnt-out safety fuse.
Replacing the fluorescent lamp
X Unscrew the cover fixing screws (2) with a cross screwdriver.
X Take the cover (3) off and rotate the lamp (1) in any direction
until the projections on the lamp align with the gutters of the
receptacle. Take the lamp out.
X Replace the lamp with a new one: insert the new lamp as far as
it goes and make a quarter turn in any direction.
Warning: do not touch the cap of the lamp.
X Close the cover.
X Screw the cover fixing screws.
Installation and transportation
X You can install the lantern on a horizontal or vertical surface
using the mounting holes (10) on the body of the appliance.
X You can carry the lantern from one place to another using the
protrudable handle (8). To do so, take the handle out by
pulling it in the direction opposite the body of the appliance.