Garmin GLO - Manual (Page 2)

2
GLO
™
GLONASS and
GPS Sensor Instructions
Installing the Battery

WArNING
This product contains a lithium-ion battery�
See page 5 for important battery safety
information�
1 With your thumbnail, slide the battery
cover release tab
➊
�
➌
➊
➋
2 Remove the battery cover ➋ �
3 Locate the metal contacts on the end
of the lithium-ion battery�
4 Insert the battery ➌ so the metal
contacts on the battery align with
the metal contacts inside the battery
compartment�
5 Press the battery down into place�
6 Insert the battery cover into the
notches and press down�
The release tab locks the cover in
place�
replacement Battery
You can purchase a replacement battery
(010-10840-00) at http://buy�garmin�com �
Charging the Battery
You can use the sensor while you are
charging it�
1 Plug the small end of the power cable
into the mini-USB connector on the
end of the sensor�
2 Plug the other end of the power cable
into an appropriate source of power for
the cable type�
It takes about three hours to charge the
battery� A fully charged battery lasts about
12 hours�
NOte: If the battery has not been charged
for a long period of time, remove the
battery, connect the cable to the device
and a power source, and then replace the
battery� The battery will charge as usual�