Garmin GPS 40 - Manual (Page 56)

Received an Invalid WPT—A waypoint was received during upload transfer that has an
invalid identifier.
Receiver has Failed—A failure in receiver hardware has been detected. If this message
persists, do not use the unit and take it to an authorized dealer for repair.
Route is Full—You have attempted to add more than 30 waypoints to a route.
Route is not Empty—You have attempted to copy into a route already in use.
Route Waypoint Can’t be Deleted—The waypoint you are trying to delete is part of a
route. You must first delete the waypoint from the route before removing it
from memory.
Route Waypoint was Deleted—A route waypoint entered does not exist in the database
and has been deleted from the route.
RTCM Input has Failed—DGPS data being received has been lost. You are no longer
receiving the beacon signal.
Searching the Sky—The GPS 40 is in searching the sky for almanac data or the unit is in
AutoLocate TM mode.
Stored Data was Lost—All waypoints, routes, time and almanac data has been lost due
to battery failure.
Transfer has been Completed—The receiver is finished uploading or downloading
information to the connected device.
WPT Memory is Full—You have used all 250 waypoints in the GPS 40. Delete unwanted
waypoints to make room for new entries.
50
Appendix B
Messages
40 rev B 8/6/98 1:48 PM Page 50