Garmin nuvi 2595LT - Manual (Page 77)

nüvi 2405/2505 Series Owner’s Manual 71
NOTE: The required fuse for your cable
is listed after "output" on the back of the
vehicle power adapter.
4 Place the silver tip in the end piece.
5 Screw the end piece back into the vehicle
power cable.
Mounting on Your Dashboard
noTICE
The permanent mounting adhesive is extremely
difficult to remove after it is installed.
Use the enclosed mounting disk to mount your
device to the dashboard and comply with certain
state regulations.
1 Clean and dry the dashboard where you are
placing the disk.
2 Remove the backing from the adhesive on
the bottom of the disk.
3 Place the disk on the dashboard.
4 Remove the clear plastic cover from the top
of the disk.
5 Place the suction cup mount on top of the
disk.
6 Flip the lever down (toward the disk).
Removing the Device, Cradle, and
Mount
Removing the Device from the Cradle
1 Press up on the tab on the top of the cradle.
2 Tilt the device forward.
Removing the Cradle from the Mount
1 Turn the cradle to the right or left.
2 Apply pressure until the socket on the cradle
releases the ball on the mount.