Garmin nuvi 780 - Manual (Page 3)


WARNING: This product contains a non-user-replaceable lithium-ion battery. See the Important Safety and
Product Information guide in the product box for important battery safety information.
State law in Minnesota and California prohibits and/or restricts drivers from using suction mounts on their
windshields while operating motor vehicles. (See California Vehicle Code 26708(a); Minnesota Statutes
Section 169.71.) Other Garmin dashboard or friction mounting options should be used in those states. Check
your state and local laws and ordinances where you drive, as other states may enact similar prohibitions or
related restrictions against windshield objects that obstruct the driver’s vision (Michigan and New Jersey law
currently prohibits windshield objects that obstruct the driver’s vision). Remember to always mount your
Garmin unit in a location that does not obstruct the driver’s view of the road. Garmin does not assume any
responsibility for any fines, penalties, or damages that may be incurred as a result of disregarding this notice or
as a result of any other state or local law or ordinance relating to use of the unit.
Step 1: Mount the nüvi
1. Plug the vehicle power cable into the power
connector on the right side of the cradle.
2. Snap the cradle onto the suction cup arm.
3. Clean and dry your windshield and the suction
cup with a lint-free cloth. Remove the clear plastic
from the suction cup. Place the suction cup on the
windshield.
4. Flip the lever back, toward the windshield.
5. Fit the bottom of your nüvi into the cradle.
6. Tilt the nüvi back until it snaps into place.
7. Plug the other end of the vehicle power cable into
a power outlet in your vehicle. Your unit should turn
on automatically if it is plugged in and your vehicle is
running.
Cradle
Power cable
Suction cup mount