Garmin StreetPilot 2720 - Manual (Page 8)

2 StreetPilot 2720 Owner’s Manual
G
ettinG
r
eady
Installing the 2720 in Your Vehicle
You can use the permanent or temporary adhesive disks,
or the non-skid friction mount, to mount the StreetPilot
in your vehicle.
Temporary
adhesive disk
Permanent
adhesive disk
To attach the mounting disk to your dashboard:
1. Clean and dry the area where you want to place
the mount.
2. Remove one side of the backing from the
adhesive and place the adhesive on the bottom
of the mounting base. Remove the backing from
the bottom of the adhesive.
3. Place the mounting base so the locking lever
is facing you and then position the base on the
cleaned area. Apply pressure to adhere the base
to the dashboard.
Note: The permanent adhesive disk is extremely
difficult to remove. Only install it if you are sure
you want to leave the mount in that location.
To mount your StreetPilot 2720:
1. Align the power plug on the vehicle adapter
to the connector and slide the plug into the
connector until fully seated.
2. Slide the locking lever on the mounting base to
the left, in the unlocked position