Bosch PTA 2000 - Manual (Page 12)

12 | English
1 619 929 K24 | (28.3.12) Bosch Power Tools
f Mount and dismount the power tool only when it is in
the transport position (for instructions on the trans-
port position, also see the operating instructions of the
respective power tool). Otherwise, the power tool can
have such an unfavourable centre of gravity that it cannot
be held securely.
f Ensure that long and heavy workpieces do not affect
the equilibrium of the saw stand. Long and heavy work-
pieces must be supported at the free end (e. g., with the
Bosch PTA 1000 roller stand).
f Keep your fingers clear of the hinge points while set-
ting up or folding together the saw stand. Danger of fin-
gers being crushed or contused.
Symbols
The following symbols can be important for the operation of
your saw stand. Please memorise the symbols and their
meanings. The correct interpretation of the symbols helps
you operate the saw stand better and more secure.
Product Description and
Specifications
Intended Use
The saw stand is intended to accommodate the following sta-
tionary saws from Bosch (as of 2012.02):
Together with the power tool, the saw stand is intended for
the cutting to length of boards and profiles.
Product Features
The numbering of the product features refers to the illustra-
tion of the saw stand on the graphics pages.
1 Handle
2 Lock/release button
3 Cross brace
4 Retaining adapter
5 Locking knob
6 Resting bar
7 Transport wheels
8 Transport handle
9 Fastening kit, power tool
10 Limit bolt of the resting bar
Accessories shown or described are not part of the standard deliv-
ery scope of the product. A complete overview of accessories can
be found in our accessories program.
Technical Data
Symbol Meaning
The maximum carrying capacity (power
tool + workpiece) of the saw stand is
125 kg.
Mount the power tool only as shown in the
corresponding figure.
(see figures B1–B2)
Observe the operating position. When
working, always position yourself on the
side of the wheels. (see figure C)
f Do not overload the saw stand and
do not use it as a ladder or scaffold-
ing. Overloading or standing on the
saw stand can lead to the upward shift-
ing of the centre of gravity of the stand
and its tipping over.
Indicates the individual steps for setting up the saw stand.
1. Pull the release button
2. Step on the transport handle and pull the handle upward
3. Firmly tighten the locking knob
Indicates the individual steps for folding the saw stand to-
gether.
1. Loosen the locking knob
2. Pull the handle upward a little
3. Pull the release button
4. Slowly lower the saw stand by the handle
– PPS 7S 3 603 M03 3..
– PTS 10 3 603 L03 2..
Saw stand PTA 2000
Article number 3 603 M05 300
Height of saw stand mm 595
Max. carrying capacity
(power tool + workpiece) kg 125
Weight according to
EPTA-Procedure 01/2003 kg 13
Symbol Meaning
OBJ_BUCH-1563-002.book Page 12 Wednesday, March 28, 2012 1:05 PM