MAXWELL MW-1101 W - Manual (Page 6)

6
ENGLISH
STORAGE
• Before taking the unit away for storage, make sure that it is disconnected.
• Follow the requirements of the CLEANING OF THE UNIT section.
• Keep the unit in a dry cool place, out of reach of children.
Troubleshooting guide
Trouble Solution
When switching on the unit for the first time
unpleasant odor appears. It is normal, as some time for seating of carbon brush
in the electric motor is necessary.
The unit does not operate
1. Check whether the unit is assembled properly, make
sure that the clamps is are locked.
2. Check the presence of voltage in the socket, for
this purpose connect any electrical appliance to the
socket.
Amount of juice is reduced
1.The shredding sieve is blocked
- switch off the juicer; take the plug out of the socket.
- when the electromotor stops, check the shredding
sieve.
- clean and wash the shredding sieve.
Strong vibration during the operation.
1. Sticking of pressed skin on the side of the shredding
sieve.
- switch off the juicer; take the plug out of the socket.
- when the electromotor stops, check the shredding
sieve.
- clean and wash the shredding sieve.
2. The shredding sieve is damaged.
- check the shredding sieve, if there are some dam-
ages or cracks, replace the shredding sieve.
The operation of the unit is accompanied
by noise, unpleasant odor, it heats up
strongly, smoke appears etc. Stop using the unit immediately, disconnect it and
apply to the authorized service center for testing and
repair.
Specifications:
Power supply: 220-240 V ~ 50/60 Hz
Maximal power consumption: 450 W
Specifications subject to change without prior notice.
MINIMUM SERVICE LIFE - 3 YEARS
GUARANTEE
Details regarding guarantee conditions can be obtained from the dealer from whom the
appliance was purchased. The bill of sale or receipt must be produced when making any
claim under the terms of this guarantee.
MW-1101.indd 6 MW-1101.indd 6 27.05.2009 9:40:48 27.05.2009 9:40:48