Audiopipe APSM-4050 es - Manual (Page 11)

IMPORTANT:
When bridging two amplifiers please refer the bridging wiring chart. •
When bridging two amplifiers you should use same model amplifiers.
•
Please make sure the negative speaker terminal of two amplifiers are connected by the
same gauge cables as the positive terminal being used. •
DO NOT connect any signal cables with the input RCA jacks when bridged as slave unit. •
•
The LPF, Input level and remote functions will be disabled on slave amplifier when
bridged.
All the functions of the slave amplifier will be adjusted by the master amplifier.
•
- 9 -
English
We recommend you have the installation done by an Authorized Audiopipe Dealer. The
ground wire should be connected directly with the chassis of your vehicle which should
be a metal to metal ground point connection. The amplifier must be mounted securely at
a solid, dry and low vibration surface in the trunk or passenger area. Mount the amplifier
in an open air area to insure proper heat dissipation. Mount the amplifier in a place where
you can access it easily to set the input controllers. Install all amplifier cables as far as
possible from car electrical cables such as the car ignition cable.