Blue Ox SC9006 User Manual
Sc9005
© 2005
Blue Ox Division, Automatic Equipment Mfg. Co. • One Mill Road, Industrial Park
Pender, Nebraska 68047 • Phone 402-385-3051 • Fax 402-385-3360 •
Installation Instructions
1. Mount the two lights to the light brackets supplied as shown above. Using a ring
connector for each light, be sure to ground each of the white wires of the 6 wire
harness as shown above.
2. Then bolt the light brackets to the deck of the carrier with 1/4-20 x 3/4" or 1/4-20 x
2 1/2" carriage bolts, 1/4" flat washers and 1/4-20 hex nylock nuts depending on
what carrier you have.
3. Continue wiring the lights with the supplied butt connectors and 3/8" shrink
tube. Note: Be sure to slide shrink tube on wire before butt conncecting
wires together. The green wire connects to the red wire of the light on the
passenger's side. The yellow wire connects to the red wire of the light on
the driver's side. The brown wire of each light connects to the brown wire
of the 6 wire harness as shown above. After butt connecting all the
wires, use a heat shrink gun on all shrink tube.
4. Connect the 4 wire flat connector to the connection on the coach and
test the wiring to make sure everthing is operating correctly. If it is,
use the loom and wire ties to secure wires in place.
SC9005
Kit, Lights, Bolt On - Used on SC2000, SC2001, SC2100, & SC2101
292-2768 9/05 Page 1 of 1
If you should have any questions, please contact Blue Ox's Sales/Service Department.