Concord TRANSFORMER X-BAG INSTRUCTION MANUAL - Manual (Page 11)

41 40
Pull the belt taut so that the lap belt and diagonal belt are well positioned and ensure
that the belts are not twisted. The lap belt should be in the lowest possible position.
If your vehicle is fitted with a seat belt height adjuster, adjust its height accordingly.
When you wish to release the child from the seat, all you need to do is open the lock
and pass the strap back across the child. To remove the shoulder belt from the guide,
press the shoulder belt locking button ( 05 ) and pull the belt forwards and out.
It is important to ensure that the belts are always correctly positioned each time the seat
is used. If in doubt about any aspect of fitting, check with CONCORD.
The belts must pass through the guides marked in red on the seat. Belts must not be
routed in any other way.
_ GENErAL iNFOrMATiON
• This is a “universal” child restraint system. It is approved for general use in vehicles
in accordance with ECE Regulation 44, Amendment 04 and fits most, but not all,
passenger vehicle seats.
• This child restraint system from ECE groups II and III is suitable for children from
3–12 years weighing 15–36 kg.
• It can be assumed that the system will fit correctly if the vehicle manufacturer states
in the vehicle manual that the vehicle is suitable for the installation of a “universal”
child restraint system for the relevant age group.
• This child restraint system has been classified as being of the “universal” class,
satisfying stricter conditions than previous models which do not bear this label.
• If in doubt, please consult the manufacturer of the child restraint system or the retailer.
• Only suitable for vehicles with three-point (lap and diagonal) seat belts tested and
approved in accordance with ECE Regulation 16 or a comparable standard.