Caution, Important – Concord AIR INSTRUCTION MANUAL User Manual
Page 7
22
23
CaUTion!
• The seat belts must not be twisted.
• The harness lock (
07
) must be locked properly and the
harnesses must lie snug against the child‘s body.
• The headrest/ harness guide must be adjusted to the size of
the child and latched securely in place.
• The carry handle (
01
) must always be locked in the
forward/down position when used in a vehicle.
• The child should remain restrained in the seat even when
outside the vehicle.
_ THE SEaT minimiSER
Image 8 - Use the seat minimiser (
06
) for infants up to a weight of
approx. 8 kg. To remove the seat minimiser (
06
), open the harness lock
(
07
) and thread it out of the slit in the seat minimiser. Then the seat
minimiser can be simply lifted out.
Do the reverse to install the seat minimiser.
Seat insert // Image 9 - The seat insert is located in the bag at the
rear of the seat minimiser (
06
) and must be removed, when the child
has reached a body weight of approx. 7 kg.
_ inSTallaTion inSiDE THE VEHiClE
CaUTion!
• The child seat must not be used on seats with activated front
airbags (mortal danger for the child)!
• The seat must only be installed facing backwards in the
vehicle!
Image 11 - Place the CONCORD AIR onto the vehicle seat facing
backwards, and open the arrester (
12
) on the rear of the CONCORD
AIR. Guide the vehicle seat belt over the seat and lock it into place.
Image 12 - The lap strap must be guided through the two harness
guides (
05
) at the foot area of the CONCORD AIR. The shoulder strap
must be guided on the belt lock side between the ProFix connector
(
15
) and the seat hollow, and placed inside the arrester (
11
).
Image 13 - Tighten the shoulder strap and lock the arrester (
11
).
imPoRTanT!
Image 14 - Move the carry handle (
01
) to the forward/down
position. Check for the proper seating of the vehicle‘s safety
belt in the relevant guides, and that the harness clamp is locked
correctly. The proper function of the child seat may otherwise not
be guaranteed.
• The vehicle safety belt must be pulled tight and must not be
twisted. Never swap around the shoulder and lap straps of the
vehicle‘s safety belts.
• The carry handle (
01
) must always be locked in the forward/
down position when using the CONCORD AIR inside a vehicle.