EVS MulticamLSM Version 10.01 - October 2009 Configuration Manual - Manual (Page 8)

EVS Multicam Version 10.01 – Configuration Manual
EVS Broadcast Equipment SA – October 2009
Issue 10.01.I
1
1. Introduction
1.1 PURPOSE AND STRUCTURE
The aim of this manual is to describe the various configuration parameters that
have to be defined when you work on a server either in Multicam LSM mode or in
Spotbox mode, via IPDirector or a third-party controller.
• Customers who use the Multicam LSM mode can configure the server and
Multicam settings either via the Setup Configuration module, or via the setup
menu of the Remote Panel.
• Customers who use a Spotbox mode will configure the server and Multicam
settings via the Setup Conguration module, available via SHIFT-F2 in Multicam.
1.2 APPLICATION SELECTION AND
CHANNEL CONFIGURATION
Prior to configuring the Multicam and server settings in the Setup Configuration
module or on the LSM Remote Panel, you must have selected the application you
will run on the server. In this step, you also define the channel configuration to be
used with the selected application, as well as several audio and video parameters
for the server.
You perform this initial step in the EVS and AVCFG software programs. The EVS
software is started when the server is switched on. For more information on this,
refer to the XT Tech Ref Software manual.
If a default application has been previously selected, this application will start
automatically after a few seconds if no key is hit.
If a default application hasn't been defined or if the space bar is hit, the system
will remain in the EVS main menu and wait for the operator's next command.