EVS Xedio Dispatcher Version 4.35 - October 2013 User Manual - Manual (Page 123)

10. Recording an Audio Guide Track
10.1. Introduction
You have the possibility to record a voice-over sequence on one track of the storyboard.
You can only record one audio guide track for one storyboard. Once the audio guide track
has been created, you cannot modify it. If you want to change it, you need to delete it and
record a new one.
By default, the audio guide track is stored and exported on the stereo track 3 of the
storyboard. The track on which it is stored is defined via the menu Parameters >
Parameter Profiles: Media Dispatcher > Default parameter profile > Storyboard tab:
AudioGuideTrackOutput setting. Audio guide track will be mixed over any existing audio
on this audio track.
10.2. How to Record an Audio Guide Track
The storyboard on which you want to add the audio guide track is already loaded in the
Storyboard Player. See section "Checking the Storyboard" on page 114.
To record an Audio Guide Track on the storyboard, proceed as follows:
1. Position the nowline where you want to start the audio guide sequence.
2. Click the Start Audio Guide button .
A countdown (default 3-second preroll) starts and is shown on the button . It
indicates the number of seconds before the recording process starts and allows you to
get ready for the recording.
3. Start speaking when the button turns red .
4. Click the button again when the voiceover sequence is finished.
The record button becomes the Delete Audio Guide button : click on this button
if you are not satisfied with the recorded audio guide, and create a new one.
Note
The default value for the Audio Track Guide Preroll can be modified in the
AudioGuideTrackPreRoll setting defined via the menu Parameters > Parameter
Profiles: Media Dispatcher > Default parameter profile > Storyboard tab.
USER MANUAL Xedio Dispatcher 4.35
10. Recording an Audio Guide Track 113