3 automatic processes at startup, Automatic processes at startup – EVS Xfile Version 2.19 - November 2012 User Manual User Manual
Page 24
Advertising
Issue 2.19.A
XFile Version 2.19 – User Manual
EVS Broadcast Equipment – November 2012
14
Note
In GBE Only mode, a longer starting sequence is needed to ping all the
servers.
If all these stages are successful, the XFile is ready to operate.
Click the Start button again to enter the application.
3.2.3 Automatic Processes at Startup
After the startup, the system automatically starts two operations: the Scanning Disk
process and the Scanning Network process.
Those operations might last a few seconds depending on the number of clips present on
disk and the number of clips present on the XNet.
Advertising