Cluster configuration, Introduction – EVS Xsquare Version 1.0 - July 2012 User Manual User Manual
Page 24
Issue 1.0.C
Xsquare – Version 1.0 – User Manual
EVS Broadcast Equipment – June 2012
18
•
IP Retry timeout (Default 5000)
•
Enable Retry (Default 1)
•
MinFieldsToWriteBeforeRefInCEDB (Default 1000)
•
EDL File extension (Default .edl)
Cluster Configuration
Introduction
The Orchestrator (Xsquare) will always send the jobs to the most available XTAccess.
But it is possible to create a group of XTAccess called “Cluster”. These clusters must be
based on the network topology or on “LIVE” aspect (backup of train real time). The
clusters will actually force the orchestration of some jobs to a specific group of XTAccess.
The goals for creating clusters could be:
•
To isolate specific important jobs (backup of train) to some specific XTAccess (LIVE
aspect).
•
To send jobs to some specific XTAccess which are the only XTaccess that can reach
the destination (network topology aspect).