EVS XTAccess Version 1.15 - January 2011 User Manual - Manual (Page 46)

XTAccess Version 1.15 – User’s Manual
Author: Serge Comes EVS Broadcast Equipment – January 2011
Issue 1.15.B
Column
Heading
Description
Target
Server
If you have selected ‘Target EVS Server’ Job Target, you can
specify here the destination EVS server and location
Server IP: IP address of the target EVS server
User : FTP login of the target EVS server
Password : password of the target EVS server
Location: ClipID of the first location to check when restoring.
4 modes are considered:
• 123X: X could be A, B, C, D, E or F. In that case XTAccess will
check the availability of the clip, e.g. 123A clip.
o
If not available, XTAccess will show an error message on
the main window. You will need to try again with a different
location.
o
If available, the transfer will be done
In any case, after each transfer, XTAccess will increase by 1
the LSM ID with the same camera label, e.g. 124 A,125A,126A.
Etc.
• 123?: In this case, the “Question Mark” allows XTAccess to
check all the camera labels. First check the availability of
123A, then 123B, 123C, 123D, 123E, 123F, 124A, 124B, etc.
• 123[XXXX]: X could be A, B, C, D, E or F. In that case,
XTAccess will check the availability of the clip in this range of
camera.
Example: 111[ACD] XTAccess will try: 111A 111C 111D 112A
112C 112D ... ... 211A 211C
• [XXX]?: X could be 123456789 and XXX is/are the page where
you want to restore the files. In this case, the “Question Mark”
allows XTAccess to check all the camera labels but after the
XXX page.
Example: [157]? XTAccess will try : [110A 111A 112A ... 199A
510A ... ... 799A 110B 111B ... 199B 510B ... ... 799B 110C ...
... ... ... ... 799F ].
These last two modes are only available with Multicam 10.01.07
or upper.
Restore Mode:
• Copy: Generates new IDs for VarID, MaterialID and UmID
(LouthID) like a Copy Job
• Lax Rest.: Typically used for automation which needs to keep
the VarID from the source file but can regenerate the
45