EVS XSnano Version 11.01 - November 2012 Configuration Manual - Manual (Page 11)

1. Introduction
1.1. Introduction to the Configuration of EVS
Servers
New Configuration Module
The Multicam Setup application is used for configuration and maintenance operations on
EVS video servers. It is also used to select which application to run, since EVS disk
recorders have the ability to run various dedicated applications (Video Server, Slow
Motion, …).
With the release of Multicam 11, a new configuration module has been implemented
aiming at simplifying and clarifying the EVS server management and configuration tasks.
The new configuration module has been developed along the lines presented in this
section.
Consolidation into a Single User Interface
The server can now be fully configured from a single user interface.
The user interface includes:
• a setup section presented on one page with two main areas which give access to the
configuration lines and the most used maintenance commands:
XSnano Server - Version 11.01 - Configuration Manual
1. Introduction 1