EVS IPDirector Version 6.2 - June 2013 CONTROL PANEL User Manual - Manual (Page 76)

4.5.3. How to Reload a Playlist
How to Cue up a Playlist on the First Element
The Recue function re-loads the playlist on the first frame of the first element.
When a playlist is loaded on a player channel or the Software Player, loading an element
type (clip, train, growing clip) on the same channel will unload the playlist from the
channel. However, it is still possible to load it again on the associated player.
It is possible to recue the playlist in one of the following ways:
• double-click the first element of the playlist in the Clip-List tab
• use the Recue function:
Operation User Interface Button Keyboard Shortcut
Recue
How to Cue on any Playlist Element
To cue up one particular element of the playlist, proceed in one of the following ways:
• double-click it on the Clip-List tab, if the Disable Double-Click on Playlist option
has not been selected under Settings > Playlist > General
• use one of the ShuttlePRO keys:
Operation ShuttlePRO key
Previous Playlist Element (only in Edit mode)
Next Playlist Element (In Edit or Play modes)
The corresponding element will then be loaded. The playlist will cue up on the first frame
of that element.
4.5.4. How to Load a Playlist Element onto the
Control Panel
To load a playlist element onto the Control Panel, proceed as follows:
1. Open the Control Panel and assign a player to it.
66 4. Loading Media
EVS Broadcast Equipment S.A. - June 2013 Issue 6.2.A