Herman Miller Mirra Chairs - Disassembly For Recycling - Manual

Z
© 2012 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Mirra, Co/Struc and Embody are among the registered trademarks of Herman Miller, Inc.
TM Sense, Setu, Tu and SAYL are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products. 1
Z Part no. 1b9rtg rev B.
Y
Mirra
®
Disassembly for Recycling
Tools Required:
Materials Identification and Segregation:
Disassembly Steps:
Power Driver
Safety Glasses
Rubber Mallet
Ratchet
T-40
Torx Bits
Flat Blade
Screwdriver
2 lbs Hammer
Where possible, plastic components are marked with ASTM recycling codes.
Use these codes to identify material type for recycling. Non marked components
should be treated as mixed plastic. Ferrous metals can be identified using a small
magnet for recycling. Non-ferrous metals should be separated and recycled
separately.
1. Using T-40 torx bit, remove
both hip pivot bolts securing
seat assembly to arm support
stems.
2. By hand, pull seat assembly
forward to disengage seat from
chair tilt mechanism.