Herman Miller Celle Chairs - Disassembly For Recycling - Manual

Z
© 2011 Herman Miller, Inc. Zeeland, Michigan. Printed in the U.S.A.
® Y, Z, Celle are among the registered trademarks of Herman Miller, Inc.
TM Sense, Setu, and Tu are among the trademarks of Herman Miller, Inc.
Illustrations and specifications are based on the latest product information available at the time of publication.
The right is reserved to make changes in design and specifications at any time, without notice, and also to discontinue products. 1
Part no. 1b9vtd rev A.
Y
Celle
®
Disassembly for Recycling
Tools Required:
Safety Glasses Ratchet
Wrench Flat
Screwdriver
Phillips
Screwdriver
Rubber Mallet Allen Wrench Nose Plier Snap Ring
Plier
Steps:
1. To remove the frame cap,
using a flat screwdriver pry
the frame cap. 2. Pull off the frame cap.
Where possible, plastic components are marked with ASTM recycling codes. Use
these codes to identify material type for recycling. Non marked components should
be treated as mixed plastic. Ferrous metals can be identified using a small magnet
for recycling. Non-ferrous metals should be separated and recycled separately.
Materials Identification and Segregation: