High Lifter Lift Kit for Yamaha Grizzly 660 (02-07) - Manual

High Lifter Products, Inc. 318-524-2270
780 N Professional Drive 318-524-2297
Shreveport, LA 71105
Yamaha 660 Grizzly Installation Instructions
Front Lift only for ATV’s with Stock Axles
Read Before Installation!
This product is designed for use on ATVs on which additional ground clearance and fender
clearance is desired. It is designed for utility type, slower-speed use on relatively flat terrain in
deep mud or snow. Although we have many thousands of satisfied lift kit customers and over 400
franchised dealers selling and installing lift kits, purchasers should be aware that use of this
product may increase the frequency of required maintenance, part wear, and will raise the center
of gravity on your ATV increasing risk of roll-over on side hills, ditches or other steep terrain.
We recommend that wider tires and/or wheel spacers be used to achieve a wider stance and to
improve stability of the ATV. Riders should be advised that the handling characteristics of a taller
ATV are different and require extra care when riding on side hills or off-camber situations. If you
further raise the center of gravity by adding heavy loads to racks or seats, the ATV must be
operated with care, at slower speeds or on relatively flat ground.
Operation of an ATV with or without a lift kit, while or shortly after consuming alcohol or drugs,
subjects the rider to the risk of serious bodily harm or possible death. This is compounded if the
rider does not wear an approved helmet and other safety gear. High Lifter urges that all approved
safety gear be worn when riding an ATV.
If this is not what you expected, or is not consistent with your intended use, you should return the
product immediately to the seller, before installation, for a refund of the purchase price; less any
fees. After installation, product is warranted for 90 days for defects in workmanship and
materials. Warranty is limited to refund of the purchase price or replacement of the kit, at the
seller’s option. It does not include any other parts, labor, components, or consequential damages.
Parts List
1- Left Twist Flat Bracket
1- Right Twist Flat Bracket
2- Square Tubing Brackets 4- 5/8” Round Spacer (Large)
2- ¼ “ Round Spacer (Small) 2- Flat Brackets
4- ¼ x 1 ¾ Hex Head Bolt 4- 10x55mm Hex Head Bolt
4- ¼” Nyloc Nut 4- 10mm Nyloc Nut
Front Lift
1) Place ATV transmission in park. Place jack under center of ATV front end and lift until front
wheels clear the ground. Be careful to support ATV properly so that it is securely supported so that
A-arms and shocks can droop to full extension.