High Lifter DynoJet Jet Kit for Suzuki LTK500 (98-02) - Manual (Page 2)

1. Remove vacuum slide from carbs. Remove stock needles & spacers, noting order of assembly.
2. Remove stock main jet. Replace with Dynojet Main Jets provided. If you are running the stock exhaust use the DJ126 below 3000 feet, DJ122 from
3000 to 6000 feet and DJ118 above 6000 feet. If running an aftermarket exhaust with a high flow baffle use the DJ132 below 3000 feet, the DJ128
from 3000 to 6000 feet and the DJ124 above 6000 feet Be sure that the jet you are changing is the main jet.
3. Install Dynojet needle on groove# 2 for applications below 5000 feet, groove #1 for above 5000 feet, using all stock spacers. Install the Dynojet
washer above the E-clip.
NOTE: You may need to enlarge the plastic spacer that is under the e-clip with a 7/64 drill, in order for it to fit properly.
4. Locate the Fuel Mixture Screw (Fig.B). Using a flat blade screwdriver, turn the mixture screw clockwise until it seats, then turn out 3.5 turns .
STAGE ONE INSTRUCTIONS
This is Groove #1.
Q305.001
Fig. A Fig. B