High Lifter Lift Kit for Arctic Cat 500i (08-09) - Manual (Page 4)

Tie Rod Installation
1. Included in this kit are two replacement tie rods.
2. Mark sure to mark the where the stock tie rod ends on the tie rod end.
3. Once you have marked both tie rod ends remove the stock tie rod and ends from the ATV.
4. Remove the tie rod ends from the stock tie rod.
5. There is a long end and a short end, make sure to attach the long end to the steering stem and the short
end to the knuckle assembly.
6. Place the stock tie rod ends onto the new tie rod provided in the kit.
7. Make sure that the ends are installed up to the marked area.
8. Install the new tie rod assembly onto the ATV.
4