High Lifter Lift Kit for Arctic Cat 700 - Manual (Page 5)

5. Place the top of the shock into the between the two rear lift brackets. Stack two washers and place next
to the top of the shock inside the two lift brackets. On the opposite side, inside the two lift brackets
attach the support bracket and secure all using the 10x50mm hex bolt and 10mm lock nut.
6. Next secure the Rear Flat Bracket to the A-arm. Remove the top A-arm nut and attach the bracket then
secure it with the nut that you removed.
7. Tighten all remaining nuts and bolts.
8. Reattach shock to A-arm. Repeat steps for the other side.
9. Install the wheels, torque all wheel lugs to factory specifications, lower and remove jack. Check for
clearance problems or misalignment.
5