High Lifter DynoJet Jet Kit for Kawasaki Teryx 750 (2008) - Manual (Page 2)

STAGE ONE INSTRUCTIONS
1. Remove vacuum slides from carbs. Remove stock needles & spacers, noting order of assembly (Fig.A).
2. Install Dynojet needles on groove #2 for applications below 5000 feet, groove #1 for above 5000 feet.
Install the Dynojet washers above the E-clip, 2 per needle (Fig.A).
3. Install the Dynojet slide springs DSP027, in place of the stock slide springs.
4.Remove the float bowls from the bottom of the carbs, remove the stock main jets and replace with Dynojet
main jets provided. When using the stock exhaust, install the DJ130 in the front carb and the DJ134 in the
rear carb below 3000 feet, DJ126 in the front carb and the DJ130 in the rear carb from 3000 to 6000 feet and
DJ122 in the front carb and the DJ126 in the rear carb above 6000 feet. When using an aftermarket exhaust
with a high flow baffle, use the DJ134 in the front carb and the DJ138 in the rear carb below 3000 feet,
DJ130 in the front carb and the DJ134 in the rear carb from 3000 to 6000 feet and the DJ126 in the front
carb and the DJ130 in the rear carb above 6000 feet.
5. Locate the Fuel Mixture Screw (Fig.B). If you see a screw head at Fig.B then proceed to the adjusting
procedure. With the 5/32 drill bit provided carefully drill through the plug. NOTE: The mixture screw is directly
underneath this plug, be ready to pull back on the drill the instant you break through. Use the screw provided
to secure and remove this plug. Carefully turn the mixture screw clockwise until lightly seated, then turn out 3
turns, 2.5 turns above 5000 feet.
Fig.A
Q221.001
This is Groove # 1
Mixture Screw plug location
Dynojet Parts
Main Jet
Fig.B