High Lifter Lift Kit for Polaris Magnum 500 (99-03) - Manual

High Lifter Products, Inc 318-524-2270
780 N Professional Drive Fax 318-524-2297
Shreveport, LA 71105
Polaris 425 Expedition/ 500 Magnum
Lift Kit Installation Instructions
Read Before Installation!
This product is designed for us e on ATVs on which additional ground clearance and fender clearance is
desired. It is designed for utility type, slower-speed use on relatively flat terrain in deep mud or snow.
Although we have many thousands of satisfied lift kit customers and over 400 franchised dealers
selling and installing lift kits, purchasers should be aware that use of this product may increase the
frequency of required maintenance, part wear, and will raise the center of gravity on your ATV
increasing risk of roll-over on side hills, ditches or other steep terrain.
We recommend that wider tires and/or wheel spacers be used to achieve a wider stance and to improve
stability of the ATV. Riders should be advised that the handling characteristics of a taller ATV are
different and require extra care when riding on side hills or off-camber situations. If you further raise
the center of gravity by adding heavy loads to racks or seats, the ATV must be operated with care, at
slower speeds or on relatively flat ground.
Operation of an ATV with or without a lift kit, while or shortly after consuming alcohol or drugs,
subjects the rider to the risk of serious bodily harm or possible death. This is compounded if the rider
does not wear an approved helmet and other safety gear. High Lifter urges that all approved safety
gear be worn when riding an ATV.
If this is not what you expected, or is not consistent with your intended use, you should return the
product immediately to the seller, before installation, for a refund of the purchase price; less any fees.
After installation, product is warranted for 90 days for defects in workmanship and materials.
Warranty is limited to refund of the purchase price or replacement of the kit, at the seller’s option.
This lift kit contains the following parts:
10mm x 65mm Bolt
1 Lift Brackets 8
8mm x 50mm Bolt 1 Pages of Diagrams 2
10mm Nylon Nut 1 Pages of Instructions 2
8mm Flat Washer 1
WARNING: The McPherson struts on the front of this ATV are preloaded and are under extreme
pressure. A spring compressor is required for the installation. Most local auto parts stores carry