High Lifter Max Clearance Front Lower Control Arms for Polaris RZR 1000 XP User Manual
Page 4
4
6. Now reinstall the bushings, sleeves, and ball joints into the new arms. If you
place some grease on them it makes the installations easier.
NOTE: A press or a vise is suggested for removing and replacing the ball
joints. If you press in the ball joint crooked, DO NOT TRY TO FORCE IT
IN! If you try to force it straight you can “egg” the opening. Press the ball
joint out and reinsert it into the opening, pressing it in with a vise. Verify
that the clip snaps into place after installing the ball joints into the new
Control Arm. You should always double check the ball joint snap ring for
proper fit. Even if you use snap ring pliers, it may not seat. You can use a
flathead screwdriver and a hammer to tap the snap ring to ensure that it is
seated into the grove.