High Lifter DynoJet Jet Kit for Kawasaki Prairie 400 (97-98) User Manual
Page 2
Advertising
1. Remove vacuum slide from carb. Remove stock needle & spacers, noting order of assembly.
2. Install Dynojet needle on groove# 3 for applications below 5000 feet, groove #2 for above 5000 feet, using all stock spacers. Install the Dynojet
washers above the E-clip.
3. Remove stock main jet and replace with Dynojet main provided. Use the DJ136 below 3000 feet, DJ132 from 3000 to 6000 feet and DJ128 above
6000Feet. Be sure that the jet you are changing is the main jet.
4. Locate the Fuel Mixture Screw. Using a flat blade screwdriver, turn the mixture screw clockwise until it seats, then turn out 2-1/4 turns .
STAGE ONE INSTRUCTIONS
This is Groove #1.
Q207.001
Fig. A
Fig. B
Fuel Mixture Screw
Advertising