High Lifter Radiator Relocation Kit - Can-Am Outlander Models - Manual (Page 5)

9. Using an open end wrench trough the face plate and a socket with an extension through
the side you should be able to fasten the nuts and bolts tight.
10. Once the kit is assembled, place the kit on the front rack and mark the holes for the water
lines that need to be cut. We chose one location to route our lines. There are many
different ways to run the lines, we chose what we thought was the easiest way. See
finished illustration.
11. Mark the areas that need to be cut. Start with a small area and expand if needed. The
Dash Board and the Central Panel are easy to take on and off, so if you need to cut more
it is easy to do.
12. Now cut holes.