iGo pm000120004 Power Smart Wall - Manual (Page 2)

If you need immediate power, press the Instant On button
once to wake up the Green outlets .
1.
4. 5.
2. 3.
Plug your Green Recommended devices into the Power
Smart Wall’s Green outlets.
Green Recommended Devices
Laptop chargers
Desktop computers
LCD monitors
Local printers
Consumer electronics chargers
(for mobile phones, Bluetooth headsets,
digital cameras, MP3 players,
GPS units, etc.) Televisions
Home audio systems
Game consoles
Battery chargers
DVD players
CD players
Electric toothbrushes
Electric razors
Plug your other devices into the Power Smart Wall’s
Always On outlets.
Always On Recommended Devices
Network Printers
Fax machines
Telephones
DVRs
Devices with clocks
Devices with a physical power
switch (e.g. lamps, fans, etc.)
CRT computer monitors
Vacuum cleaners
Devices with heating elements
(e.g. coffee makers, hairdryers,
toasters, space heaters, etc.)
Aquarium heaters or pumps
Any device that could cause
injury or damage
(e.g. power saws, lawn mowers, etc.)
When devices are off, disconnected or in standby,
the Power Smart Wall enters “Green Mode”
and will shut the Green outlets off.
When in Green Mode, the Green Indicator
lights will flash slowly.
Every 30 minutes the Power Smart Wall
checks to see if your devices need power.
If your devices need power, the
Green outlets will provide it.
12
6
9 3
When your devices are turned off or in standby, press
and hold the Instant On button until the Green Indicator
LED begin flashing rapidly and then release.
When the LED has stopped flashing, your Power Smart
Wall will be set to recognize that your devices are off
or in standby.
NOTE: This process should be performed during initial
setup or anytime you change the devices that are plugged
into the Power Smart Wall’s Green Outlet.
Press and hold the Instant On button until the Green
LED starts flashing, and continue to hold for 10-15 seconds
until the LED stops flashing. Your Power Smart Wall is
now restored to its factory settings. Power Smart Wall’s two Green Outlets are managed together. For best results,
plug devices with similar power needs into the Green outlets.
Examples of
High Draw Devices:
Desktop computers
Monitors
Printers
Game consoles
Examples of
Low Draw Devices:
Mobile phones
Bluetooth headsets
Digital cameras
MP3 players
NOTE: Unplugging or turning off the main power will
not reset the Power Smart Wall.
Optimize the Power Smart
Wall’s Behavior
Group Similar Devices Together Reset to the Original Factory Settings
If Devices Are Not Going Into Green Mode
Standar
d Setup
Optimiz
e Y
our
Setup
(optional)
Congratulations on your
purchase of an iGo Power Smart
Wall power management system.
• With your Power Smart Wall
you can now eliminate up to
85% of vampire power in your
home, office and home theater.
• The Power Smart Wall makes
it easy for you to conserve
electricity.
Your Power Smart Wall is designed
to work right out of the box,
however you can maximize your
savings with the push of a button.
Just follow these few simple steps
to Optimize Your Setup and start
saving even more.
iGo green
TM
By following these steps the Power Smart
Wall automatically senses the power needs
of plugged in devices providing power
when they need it and shutting down when
they don’t.