iGo ps002720001 Power Splitter - Manual (Page 2)

Quick Connect Guide
IMPORTANT NOTICES
Please read the following carefully before using
the iGo ® power splitter.
When using iGo power splitter to charge two
devices, the maximum power output of your iGo
charger is shared between both devices. Most
individual devices and combinations of devices
should charge. However, if a device attached to
iGo power splitter is not charging or is displaying
an abnormal charging indication, it may need
more power than can be delivered at that
particular time. If this occurs, try one or more of
the following:
1. Turn off the device(s)
2. Detach one of the devices
3. If the problem persists, remove the splitter
and connect your device and the appropriate
tip directly to your iGo charger.
Note:
The iGo power splitter may not support
devices that have completely dead batteries.
These types of devices may need to charge alone
before attempting to share power or may need
to charge in the “off” state while sharing power.
COMPATIBILITY
The following iGo power tips will not work
with iGo power splitter:A06,A07,A08,A15,A17;
A01 Rev. 01 and A61 Rev. 01. Check the label
on your tip to verify.
iGo
®
power tips
(sold separately)
iGo ® chargers
(sold separately)
splitter_UG_2.qxp:Layout 1 4/13/07 2:39 PM Page 3