KC HiLiTES KC #6316 Add-on Harness for 2 Additional Lights Installation - Manual

This add-on harness, when used with an existing KC harness, will enable you to power
one or two additional lights with the switch on your existing harness.
1. Mount the relay within 6” of the relay on your existing light harness using one of the
screws enclosed.
2. With one of the screws enclosed, attach the ring terminal on the black ground wire to a
good clean metal grounded surface. (the relay mounting screw may be a good ground)
3. Run each of the red and black wire sets out to your two new additional KC lights and plug
the red wire into the red on the light and the black wire to the black on the light.
4. Using the enclosed wire splice, attach the 8” green wire from the add-on harness to the
green wire of the existing harness.
5. Attach the yellow power wire to the battery
or other 12 volt source.
6. Secure the wiring using the enclosed
wire ties.
7. Your done.
Installation Instructions
KC 6316 Add-on Harness
for 2 Additional Lights
KC HiLiTES, Inc., 2843 West Avenida de Luces, PO Box 155, Williams, AZ 86046 * 800-528-0950 * www.kchilites.com KC 3264V - rev 100604
23 Year Warranty
See details on our website at
www.kchilites.com
IF YOU HAVE ANY PROBLEMS OR QUESTIONS, PLEASE CALL
CUSTOMER SERVICE AT 800-528-0950