KC HiLiTES KC #340 4 LED Cube Light System Instructions - Manual (Page 2)

circuit that is capable of handling the 6 amp power draw required by the KC LED lights. F150
Raptor is also equipped with four (4) pass-through 12 gauge wires. These wires are located
inside the right hand kick panel, then pass through the dash panel and end under the hood at
the right hand fender, inside, near the hood hinge and AC hard line. If necessary, please
consult the F150 Raptor Owner Guide supplement for the latest wiring information with wire
colors.
2. Remove the right hand kick panel and right hand end cover of the instrument panel inside the
vehicle to access the eight (8) blunt cut wires. Four (4) of the wires are colored as follows:
Yellow, Green w/Brown Stripe, Violet w/Green Stripe and Brown. The only wire used for this
installation is Brown. This wire is covered with black shrink wrap. Strip insulation and shrink
wrap on the Brown wire from Relay #4. Remove the shrink wrap from one of the solid color
pass through wires. For future reference and consistency we recommend using the solid Red
pass-through wire for lighting. Attach the Red wire to the Brown wire using the supplied
standard butt connector. The other end of these pass-through wires will be located under the
hood.
3. The pass-through wires are located under the hood on the passenger side inner fender near the
AC hard lines. They are “blunt cut” and individually capped with shrink wrap.
4. Strip and prepare your selected pass-through wire for connection. Attach the supplied
weathertight butt connector to the Red pass-through wire from step #3 above.
ROUTING THE LIGHT HARNESS
1. Find the two connectors at the end of the KC harness and attach to each of the driver
side lights. Feed the harness across the front and attach the other two connectors to the
passenger side lights. Secure the harness as necessary using the supplied wire ties.
2. Continue feeding the harness through the radiator support along the passenger side of
the engine compartment until you reach the pass-through wires near the AC hard lines.
Attach the Red KC harness wire to the Red pass-through wire with the
weathertight butt
connector (apply heat to make weather-tight) and the black wire to negative or chassis
ground (there is a grounding screw on the side of the fender well near the pass-through
wires).
AIMING YOUR LIGHTS
1. Since lights such as these are not legal on any public road or highway, aiming your off
road or competition lights is entirely up to you. Most prefer the beam as far down the
road as possible, others adjust them slightly off to the sides.
2. After aiming the lights to your preference, tighten all hardware.
YOU’RE DONE
KC HiLiTES, Inc., 2843 West Avenida de Luces, PO Box 155, Williams, AZ 86046 * 800-528-0950 * www.kchilites.com KC3265AT - 042913