KC HiLiTES KC #7416 Windshield Mount Light Bar Fits All TJ and LJ Model Jeeps Installation - Manual

Thanks for choosing a KC HiLiTES product. We take pride in building the highest quality, best engineered systems possible. Your
satisfaction with our product is important, so if you have any questions, please call our customer service line at 800-528-0950 or
928-635-2607.
Parts Included Tools Required
1 - Center Cross Bar w/4 Tabs 6 - 5/16” x 1 1/4” Allen Head Bolts T-40 Torx bit
2 - Support Brackets (left & right) 2 - 5/16” x 1” Hex Head Bolt 5/32” & 3/16” Allen Wrench
2 - Plastic End Caps 2 - 5/16” Flat washers 1/2” Box End Wrench
1 - 5/16” x 1 1/4” Set Screw 2 - 5/16” Lock Washers White multi-purpose grease
NOTE - We recommend using a light duty LOCTITE on all windshield bracket mounting bolts.
Installing the Bar
1. Beginning on the driver’s side, remove the center factory torx head bolt from the side of the upper windshield hinge
bracket. Insert the supplied set screw temporarily in its place. This will ensure the plate inside does not get out of
alignment. Now remove the remaining three bolts (two on the side and one on the front).
2. Place the driver’s side light bar support bracket in position on the windshield
hinge over the set screw already in place. Hand tighten one of the 5/16 Allen
head bolts in both the upper and lower bracket holes. Remove the set screw and
loosely fasten the other Allen head bolt. Now hand tighten one of the hex bolts,
flat and lock washers to the front of the support bracket.
3. Lubricate both ends of the center bar with a multi-purpose grease. THE KNOBS
ARE PREASSEMBLED AND SHOULD NOT BE REMOVED FROM THE BAR. With light
tabs aimed upward, align the slot in the center bar with the threaded part of the
knob on the inside of the support bracket. (Fig. 1) Slide into place and turn
center bar counterclockwise until light tabs are level. Tighten knob to secure.
(Do not over tighten)
4. Repeat the procedure on the passenger side ensuring that you slide the passenger side mounting support bracket onto
the center bar before attaching to the windshield hinge.
DO NOT FULLY TIGHTEN ANY BOLTS AT THIS TIME
5. After ensuring all parts are in alignment, you may now tighten all bolts and knobs. Check all bolts for tightness after
the first 500 miles of use.
Rotating the Bar
If necessary, you may rotate the center bar forward for less wind resistance or clearance to enter your garage. Simply
loosen the two knobs slightly and rotate the bar and lights forward. Re-tighten the knobs.
You’re DONE! - - - - - - - Install your KC lights and enjoy.
Installation Instructions for KC 7416
Windshield Mount Light Bar
Fits All TJ and LJ Model Jeeps
KC HiLiTES, Inc. 2843 W. Avenida de Luces, Williams, Arizona 86046-0155 * 800-528-0950 * www.kchilites.com KC3267A - 113011
IF YOU HAVE ANY PROBLEMS
OR QUESTIONS, PLEASE CALL
CUSTOMER SERVICE AT 800-528-0950
See details on our website at
www.kchilites.com
23 Year Warranty
Fig. 1
Rear of
vehicle
Push in and turn
counterclockwise