Longacre Air Tank_Filler Gauge - Manual

Air Tank / Filler Gauge
1) Install your style air quick change fitting in the brass push-button valve (1/4” NPT).
2) Connect your quick change fittings to the end of the red hose and in the filler gauge
(1/4”NPT).
3) Open the black master valve – turn counterclockwise (MUST be open).
4) Connect your air supply line. Push the button valve. The air tank should fill in less
than 10 sec.
DO NOT EXCEED 125 PSI.
1)Push-Button Valve
Tank Gauge:
Filler Gauge
DO NOT EXCEED 125 psi.
1) Connect Filler/Gauge to short red air line from tank.
2) Hold chuck on tire valve stem. Use lever to add air. Release to see pressure on
gauge. Bleed off excess pressure with button on side of gauge.
• Filler gauge can and should be used as your regular tire gauge for
consistency.
Misc. Other Notes:
• When used without tank, air can be bled rapidly from the tire by pushing the
lever rather than the bleed button.
• Always use “dry” air. Drain the tank as needed to prevent moisture buildup.
• NEVER EXCEED 125 psi.
4) Your
Air Line
And
Quick
Disconnect
Fitting
2) Red Hose
To Filler/
Gauge
3) Black
Master
Valve