Longacre 78110 Digital Kart Camber Gauge with AccuLevel (version 3) User Manual
Longacre For the car
Instructions For No. 78110 Kart Digital Caster/Camber Gauge
1) Find a level place to set up your front end. This unit reads camber very accurately. Unlevel
ground will affect that accuracy.
2) Attach the gauge to the spindle by screwing onto the extra threads outside the nut. If there
are none remove the nut and screw the adaptor on until the the hub is tight. When done reinstall
the spindle nut and pre-load bearings as required.
BE SURE WHEELS ARE POINTED STRAIGHT AHEAD WHEN SETTING CAMBER.
3) Rotate the gauge until the small vial on the top of the gauge shows level.
4) CAMBER: Turn on the
AccuLevel™
Digital Readout by pushing “ON/OFF”. Camber is
read directly on the display to .1
O
(1/10
O
). See separate
AccuLevel™
below instructions if
needed. On the left side of the display a pointing up indicates negative camber (top of tire
in). A pointing down indicates positive camber (top of tire out). Race cars usually use nega-
tive camber on RF and positive camber on LF.
5) CASTER: To set caster more precisely using the
AccuLevel™
digital readout first turn the
wheels 15
O
(this is different than when using vial type gauges) to the right when setting the RF
or 15
O
left when setting LF. Rotate the gauge until it is level.
6) Turn on the
AccuLevel™
and push ZERO (may be marked “C” on some models) to zero
degrees at that point (shows
00.0
00.0
00.0
00.0
00.0
O
).
7) Turn wheels back to center and continue to 15
O
in the other direction (a total of 30
O
). Again
this is different than when using vial type gauges.
The 15
O
must be done accuretely. An error
of even 1 or 2
O
turning will give a noticeable caster error.
8) Rotate gauge to level. Read the digital display and DOUBLE THE NUMBER FOR (TOTAL)
CASTER, accurate to .1
O
. For example display reads 4.8
O
x 2 = 9.6
O
caster.
Monroe, Wa 360 453 2030 www.longacreracing.com
3/07
Ver 2 & 3