Longacre 78402 No Sweep Spindle Adapter - P_N - Manual

Face of Spindle Adaptor .
4 small round
head screws for
fine adjustment
Center mounting
bolt - use 1/4”
Allen wrench
Triangle shaped ‘feet’
center the
Spindle
Adaptor inside the
spindle.
Slide the feet around so
they are equally spaced
around the outside.
Tighten center bolt until Spindle
Adaptor will just slide inside
spindle. Rotate until groove is
level, then tighten center bolt.
Note how bar on screw-on adaptor engages
with groove in
Spindle Adaptor .
Figure A
Spindle Adaptor must
stick out from the
spindle 1/16”
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
12345678901234
spindle
Spindle
Adaptor
1/16”
groove -
bottom flush
with end of
spindle
Figure B
Figure C
Figure D
Figure E